Download HP A RF IMPEDANCE-ANALYZER OPERATION SM service manual & repair info for electronics experts. The HP A RF Impedance Analyzer measures 14 parameters Parameter measured: IZI, Swept measurement: manual or automatic sweep from start to. Agilent A Test Fixture. Operation and Service Manual. Third Edition. Agilent Part No. February Printed in Japan.

Author: Akinokus Dogrel
Country: China
Language: English (Spanish)
Genre: Career
Published (Last): 13 September 2012
Pages: 57
PDF File Size: 1.93 Mb
ePub File Size: 19.26 Mb
ISBN: 181-3-85945-549-3
Downloads: 48352
Price: Free* [*Free Regsitration Required]
Uploader: Zunos

I suspect that this difference might be causing my problems.


Message 3 of 6. If not, what would creating a driver for it entail? I have worked with the A and, as I recall, the commands are nothing like any other instrument I have seen.

Would you mind posting the code you used on the A? I have not worked with that instrument, but the Agilent web site has the operating and service manual here.

Good luck with it In particular, after setting up and initiating the instrument, I am initiating the measurement and reading it as follows: Accepted by topic author Matt C. I think the would probably take the old commands, but the ALSO has new commands. Message 1 of 6.


IIRC, the sweep parameters were msnual like this: Message 4 of 6. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

I am able to communicate with the device through the GPIB interface, and am also able to retrieve information. Sorry, that last line of code there is supposed to read: Most Active Software Boards: Message 5 of 6. Thanks for your help guys. Has anyone done anything on interfacing with the A since Matt Hpp4191a last post?

It’s 84MB, so I hope you have a fast link. Should I be looking at doing it with LabView or something else? However, rather than being returned the data at MHz, I am returned the data at whatever frequency the analyzer is currently set at. Message 2 of 6. Message 6 of hhp4191a.

Agilent / HP 4191A RF Impedance Analyzer

The forums emoticons took over for a bit there. You really need the manual.

Matt – you’re right, the commands for the A are completely different from the – probably because of its up4191a. In particular, after setting up and initiating the instrument, I am initiating the measurement and reading it as follows:.


Guess you never know until you try!

A RF IMPEDANCE ANL [Obsolete] | Keysight (formerly Agilent’s Electronic Measurement)

Up4191a I gave it a try, though, it worked fine. I went through the manual before, but when I saw their GPIB section, the strings were so convoluted and so unlike anything I’ve ever seen before that I assumed it was referring to something different. In the code above, MHz is an arbitrary frequency.